Stored values comparison

[RedBrain]

And why I see stored value for only one runner in one-click screen?

Your help is very appreciated!

[Dallas]

There is a few examples in this thread in the new 'tips and tricks' section which show how to use SV on the one click screen
viewtopic.php?f=61&t=16350

[RedBrain]

There is a few examples in this thread in the new 'tips and tricks' section which show how to use SV on the one click screen
viewtopic.php?f=61&t=16350

Thank you. This was a solution.

As for this strange behaviour of triggers. I just copied the ruleset and changed the book% to odds. It woks differently. It seems that book% as I supposed sligltly changes every time. But I don't understand why it rewrite the vvariable with greater value if condition is LESS ????

[jimibt]

There is a few examples in this thread in the new 'tips and tricks' section which show how to use SV on the one click screen
viewtopic.php?f=61&t=16350

Thank you. This was a solution.

As for this strange behaviour of triggers. I just copied the ruleset and changed the book% to odds. It woks differently. It seems that book% as I supposed sligltly changes every time. But I don't understand why it rewrite the vvariable with greater value if condition is LESS ????

whereas odds DECREASE in value, the associated book'% increases in value as the odds decrease - i.e. 2 odds = 50%, 5 odds = 20% etc...

[RedBrain]

Yes, and I store into variable increasing odds and decreasing book%, and I use less. But in any case this condition must work and make the rule record variable in ONE direction (always decreasing or increasing). but it record lower and greater values as I see..

[RedBrain]

automation_pic8.png

Finally I found a solution. This seems to be related to how these variables handled inside BA. Don't understand the difference between these two - current selection=nominated selection so it should apply to the same runner.

Anyway, now it works how it should. And summer is here...

[RedBrain]

automation_pic4.png

Unfortunately, ajustment in BA can't be relative - this make very hard to work with book% maybe it should be added. I will send them email on this.

Its there already 'amount'

Finally figured out how this works. And this is not I was talking about.
Right now I had a rule triggered by book% increase in 5%

book1.PNG

Actually book% was increased from 34% to 39% , but it's absolute increase while I was talking about relative. I was expecting rule to be triggered at 34*1,05=35,7%